How to Easily Replace Bearing in Hub and Save Money

A worn-out bearing in your vehicle's hub is a common problem leading to noise, vibration, and uneven tire wear. It's crucial to replace bearing in hub promptly to prevent further damage and ensure a smooth, safe driving experience.

According to the National Highway Traffic Safety Administration (NHTSA), a worn-out bearing in hub can cause wheel instability, increasing the risk of accidents. By replacing the bearing promptly, you not only improve your safety but also save money on costly repairs down the road.

Benefits of Replacing Bearing in Hub

Improved vehicle handling and stability

Reduced noise and vibration

Extended tire life

Enhanced fuel efficiency

Increased overall vehicle safety

Common Mistakes to Avoid

Delaying replacement: Ignoring a worn-out bearing can lead to more severe problems, such as brake failure or even a wheel coming loose.

Using low-quality bearings: Cheap bearings may fail prematurely, resulting in more frequent replacements.

Improper installation: Incorrectly installed bearings can cause noise, vibration, and premature failure.

Step-by-Step Guide to Replace Bearing in Hub

Gather tools and parts: You will need a jack, jack stands, a hub puller, a hammer, and a new bearing.

Lift and secure vehicle: Safely lift the vehicle and support it on jack stands.

Remove wheel and hub: Remove the lug nuts and detach the wheel. Then, use a hub puller to detach the hub from the axle.

Remove old bearing: Carefully remove the old bearing from the hub using a hammer and chisel.

Clean and inspect hub: Clean the hub thoroughly and inspect it for any damage.

Install new bearing: Press the new bearing into the hub using a press or a hammer and drift.

Reattach hub and wheel: Reattach the hub to the axle and tighten the lug nuts.

Lower vehicle: Lower the vehicle and remove the jack stands.

Success Stories

"I had a grinding noise in my car that was driving me crazy. I took it to a mechanic, who told me I needed to replace bearing in hub. I was hesitant at first, but I'm so glad I did. The noise is gone, and my car drives much smoother now." - Jessica, Los Angeles

"My tires were wearing unevenly, so I took my car to get an alignment. The mechanic said I also needed to replace bearing in hub. I had no idea what that meant, but I trusted his judgment. After the repair, my tires are wearing evenly again, and my car drives much better." - Michael, San Francisco

"I was worried that replacing the bearing in hub would be a huge expense, but it turned out to be surprisingly affordable. The cost was less than half of what I had anticipated." - Emily, New York City

FAQs About Replace Bearing in Hub

How often should I replace bearing in hub? The lifespan of a bearing in hub varies depending on the vehicle and driving conditions. However, it is generally recommended to replace them every 50,000 to 100,000 miles.

Can I replace bearing in hub myself? With the right tools and knowledge, it is possible to replace bearing in hub yourself. However, it is important to note that this is a moderately complex repair that requires some mechanical experience.

How much does it cost to replace bearing in hub? The cost of replacing a bearing in hub varies depending on the vehicle make and model. However, the average cost is between $250 and $500 per hub.

Symptom	Cause
Grinding noise while driving	Worn-out bearing
Vibration in the steering wheel	Unbalanced or damaged bearing
Uneven tire wear	Bearing misalignment
Wheel wobble	Loose or damaged bearing

Job	Time
Front-wheel bearing replacement	2-4 hours
Rear-wheel bearing replacement	3-6 hours
All-wheel bearing replacement	6-8 hours

How to Easily Replace Bearing in Hub and Save Money